Once you have set up your printer for your first print, please download the Stanford Bunny to test in your new 3D Printer.


The best settings to use for this 3D print are:

  • Decrease the scale by 0.5 (Half)
  • Layer Thickness: 0.25 mm
  • Infill: 15%
  • Quality: Normal


Under Preference set:

  • Support Angle: 30 Degrees
  • Check Easy to peel


Also if you are printing with ABS, please also check "Preheat"


Note: If "Preheat" is selected you may find that the printer can take a lot of time to start the print, this is normal and is due to the printer heating the platform to the temperature specified in the preset.